Home

Repair

Boat repair in Long Beach, San Pedro and LA County: engines, electrical, outdrives, steering, fiberglass and paint, done at your slip. Get a quote.

  • 103 services
  • Labor $150/hr
  • Trip fee from $30
  • At your slip or in the shop
View as Grid List

Items 13-24 of 103

Set Descending Direction
  1. Cooling System Pressure Testing
    Rating:
    100%
    $150 /hr
    About 1 hour
  2. Cooling System: Impeller & Thermostat Service
    Rating:
    100%
    $150 /hr
    Usually 2–4 hours
  3. Custom Boat Lettering & Marine Graphics
    Rating:
    100%
    $150 /hr
    Quoted after inspection
  4. Damper Plate Replacement Idle Rattle
    Rating:
    100%
    $150 /hr
    Quoted after inspection
  5. Diesel Injection Pump Timing & Calibration
    Rating:
    100%
    $150 /hr
    Usually 2–4 hours
  6. Digital Switching Systems & NMEA 2000 Networking
    Rating:
    100%
    $150 /hr
    Quoted after inspection
  7. Distributor Cap, Rotor & Spark Plug Replacement
    Rating:
    100%
    $150 /hr
    Usually 1–2 hours
  8. Electronic Control Module (ECM) Scanning
    Rating:
    100%
    $150 /hr
    About 1 hour
  9. Engine Overheating Diagnosis & Cooling System Flush
    Rating:
    100%
    $150 /hr
    About 1 hour to diagnose, then a quote
  10. Exhaust Flapper & Shutter Service
    Rating:
    100%
    $150 /hr
    Usually 2–4 hours
  11. Exhaust Manifold Repair & Replacement
    Rating:
    100%
    $150 /hr
    Usually 4–8 hours
Page
per page

Boat Repair in Long Beach and San Pedro

We repair boats at your slip, dock or storage yard from Marina del Rey to Newport Beach, or at our San Pedro shop. Breeze Marine Boat Service works on Mercury, MerCruiser, Yamaha, Volvo Penta, Indmar, Yanmar and Cummins engines.

What the work covers

Boat repair here runs from a single faulty switch to major engine work. Start with the area closest to your problem:

  • Engines and fuel: marine engine repair, hard starting, overheating, carburetors, fuel injectors, fuel pumps, ignition and exhaust manifolds.
  • Electrical: marine electrical repair, batteries and charging, starters, alternators, shore power and electronics.
  • Drive and steering: outdrive repair, transmissions, propellers, shift and throttle cables, and cable or hydraulic steering.
  • Onboard systems: generators, water pumps, bilge pumps, marine toilets and air conditioning.
  • Hull and finish: cosmetic fiberglass repair and gelcoat, paint repair and teak; structural hull work goes to a boatyard.
  • Trailers and inspections: trailer bearings, lights and bunks, and pre-purchase inspections.
  • Insurance: after a collision or storm, we document the damage with photos, give you a written estimate to send to your insurer and do the repair once you approve it; the claim stays between you and your insurer. See insurance repair estimates.

Parts come with the repair and are quoted with the job.

When to call

  • The engine cranks but will not start, or does not crank at all
  • The temperature gauge climbs or an overheat alarm sounds
  • The bilge pump runs more often than it used to
  • Shifting feels stiff, or the boat clunks into gear
  • The steering feels stiff or loose, or leaks fluid
  • Cracks, chips or soft spots show up in the hull or deck

Questions about boat repair

Do you come to the boat?

Yes. We work at your slip, dock or storage yard from Marina del Rey to Newport Beach. If a job is better done at our San Pedro shop, we agree that with you before work starts.

What happens if you find more work?

We quote any repair we find during a check before any work is done, so you decide what goes ahead.

Book a visit: submit a ticket with the boat, where it is kept and what you are seeing, or call (562) 542-7296.

See also: fiberglass boat repair at the slip cracks chips and leaks.

See also: spongy or stiff hydraulic steering air fluid and seals.