Question 1

Can you fix scratches and paint chips on my fiberglass hull?

Lukas · Accepted Answer

Yes. We repair gelcoat scratches, paint chips and surface damage with marine coatings tinted to match your hull as closely as possible. On older or faded finishes a slight difference can remain, and we tell you before we start.

Question 2

What causes boat paint to fade or peel over time?

Lukas · Accepted Answer

UV exposure, salt water, poor surface preparation or low-quality paint can lead to fading, chalking and peeling. Before painting we clean the area, remove the wax and sand it, and we use marine paints made for the surface.

Question 3

Do you offer color matching for older or custom-painted boats?

Lukas · Accepted Answer

Yes. We match the paint to the color around the repair, on older and custom finishes too. Faded, metallic and custom colors are harder to match exactly, so if a repair is likely to show, we tell you before we start.

Question 4

How much does paint repair or touch-up typically cost?

Lukas · Accepted Answer

Labor is $150 an hour plus materials and a trip fee for work at your boat ($30 in San Pedro up to $110 in Newport Beach). A typical touch-up takes 2-4 hours; larger repairs are quoted after we see the boat. You get a written estimate before any work, and nothing is done without your OK.

Question 5

Can you fix dock rash and scuffs along the hull sides?

Lukas · Accepted Answer

Yes. Dock rash is one of the most common cosmetic repairs. We sand, fill and refinish the scuffed area with paint or gelcoat matched to the hull, and if the repair is likely to show, we tell you before we start.

Question 6

Do you work on painted aluminum boats too?

Lukas · Accepted Answer

Yes. We take flaking or oxidized paint on aluminum back to sound metal, prime the bare spots with a primer made for aluminum and finish with a topcoat made for metal.

Question 7

Is paint repair done at the dock or do I need to haul out the boat?

Lukas · Accepted Answer

Many touch-ups and side repairs can be done dockside. For major restoration or full repaint, we recommend haul-out. We’ll advise based on the location and extent of the damage.

Question 8

Do you provide bottom painting for sailboats, powerboats, and yachts?

Breeze Marine · Accepted Answer

Yes. Trailer boats up to 26 ft are painted at our San Pedro shop for $55 a foot of boat length, paint included. Sailboats, powerboats and yachts that are bigger or kept in the water get a written quote, and the work is done at a boatyard. We match the paint to the hull and to how the boat is used.

Question 9

Can you haul out my boat or work with the yard I choose?

Breeze Marine · Accepted Answer

We don't haul boats ourselves. Trailer boats up to 26 ft come to our San Pedro shop ($55 a foot, paint included). For a boat in the water we work at a boatyard in San Pedro, Wilmington, Long Beach or Marina del Rey, or at the yard you prefer if it allows outside contractors; the haul-out and yard charges are yours and are listed on your written quote.

Question 10

What type of antifouling paint suits Southern California waters?

Breeze Marine · Accepted Answer

In Southern California marinas we usually recommend a copper-based ablative or hybrid antifouling paint, which resists the barnacles, algae and slime that grow in warm Pacific water. Racing and fast boats usually get a hard paint.

Question 11

How often should I repaint the bottom of my boat?

Breeze Marine · Accepted Answer

Most boats need bottom paint every 12–24 months, depending on usage, water conditions, and whether the boat stays in the slip year-round.

Question 12

Do you sand, prep, and repair the hull before painting?

Breeze Marine · Accepted Answer

Yes. Our $55-a-foot bottom job (trailer boats up to 26 ft at our San Pedro shop, paint included) covers washing, scraping, light sanding and two coats of ablative antifouling. Stripping old paint, blister repair, a barrier coat, zinc replacement and prop or shaft work are quoted separately after we see the hull, and nothing is done without your OK.

Question 13

Can you recommend eco-friendly antifouling options for California marinas?

Breeze Marine · Accepted Answer

Yes. We can use low-VOC, eco-friendly antifouling paints that are legal for use in California, which suit marinas with strict environmental rules.

Question 14

Do you offer prop speed, running gear coating, and zinc anode service?

Breeze Marine · Accepted Answer

Yes. During a bottom job we can coat props, shafts and struts with a foul-release coating such as PropSpeed and replace the zinc anodes. These are quoted separately from the $55-a-foot price.

Question 15

Do you create custom boat names, registration numbers, and vinyl graphics?

Breeze Marine · Accepted Answer

Yes — we design and install custom boat names, CF numbers, vinyl lettering, hull decals, and full marine graphics tailored to your boat’s style and size.

Question 16

Can you come to my slip to install the lettering?

Breeze Marine · Accepted Answer

Yes. We install lettering at your slip or dock anywhere from Marina del Rey to Newport Beach, usually without a haul-out, or at our San Pedro shop. Each visit to your boat has a one-way trip fee by distance ($30 in San Pedro up to $110 in Newport Beach); there is no trip fee at the shop.

Question 17

What material do you use for marine lettering?

Breeze Marine · Accepted Answer

We use premium marine-grade vinyl, UV-resistant and saltwater-safe, designed to handle sun exposure, abrasion, and harsh coastal conditions.

Question 18

Can you match the style of my previous boat name or create something custom?

Breeze Marine · Accepted Answer

Yes — we can recreate existing designs or develop a completely custom graphic, font, color theme, or logo based on your vision.

Question 19

Do you remove old decals and prepare the surface before applying new graphics?

Breeze Marine · Accepted Answer

Yes — we handle everything: old vinyl removal, adhesive cleanup, polishing, surface prep, and precise installation of your new lettering or graphics.

Question 20

How long does marine vinyl lettering last in Southern California sun?

Breeze Marine · Accepted Answer

It depends on the film, the color and how much sun the boat gets; dark colors and surfaces facing the sun fade first. Good marine-grade cast vinyl lasts for years in Southern California, and the film maker's outdoor rating is the best guide.

Boat Paint Repair

Boat Paint Repair in Long Beach and San Pedro

What the work covers

Signs your paint needs attention

Questions about boat paint repair

Is my boat painted or gelcoated?

Why fix small chips right away?