- Manufacturer Breeze Marine Boat Service Remove This Item
Boat Carburetor Repair
Boat carburetor cleaning, rebuilds and tuning for outboard and sterndrive engines, at your slip from Marina del Rey to Newport Beach or at our shop.
- 7 services
- Labor $150/hr
- Trip fee from $30
- At your slip or in the shop
Boat Carburetor Repair in Long Beach and San Pedro
We clean, rebuild and tune marine carburetors at your slip, dock or storage yard from Marina del Rey to Newport Beach, or at our San Pedro shop. That includes older Mercury and Yamaha outboards and carbureted MerCruiser and Volvo Penta sterndrives.
What the work covers
A marine carburetor rebuild and tuning takes the carburetor apart, clears the jets and fuel passages, replaces gaskets and worn parts, and sets it up again on the engine. Parts are quoted with the job. Related work:
- Marine carburetor cleaning and rebuilding for varnish deep in the small passages
- Idle speed and mixture optimization for an even idle and a clean pickup
- Multi-carb synchronization and tuning for engines with more than one carburetor
- Choke system adjustment and repair for hard cold starts
- Carburetor jetting for altitude or performance, useful if you trailer the boat to a lake at elevation
- Fuel water separator installation to stop water and dirt before they reach the carburetor
Signs your carburetor needs work
- Hard starting, or the engine runs only with the choke on
- Rough idle, or stalling when you shift into gear
- Bogging or hesitation when you open the throttle
- A fuel smell or fuel dripping from the carburetor: do not start the engine, air out the boat and have it checked
- Black smoke or fouled spark plugs
Questions about boat carburetor repair
Why do boat carburetors clog?
Gasoline goes stale when a boat sits, and ethanol blends can leave varnish in the jets. Water in the fuel adds corrosion. Running the engine regularly, using a fuel stabilizer and fitting a fuel water separator all help.
Should I rebuild my carburetor or replace it?
Many carburetors rebuild well. If the body is cracked or badly corroded, we tell you and quote a replacement before any work is done.
Book a visit: submit a ticket with the boat, the engine, where it is kept and how it is running, or call (562) 542-7296.
See also: boat bogging at full throttle testing a marine fuel pump.
See also: re jetting a marine carburetor for high altitude lakes.
-

#553 Common question asks
Can improper carb synchronization damage my engine?
-

Yes. Poor synchronization can cause uneven cylinder loading, overheating, spark plug fouling, and premature engine wear. Over time, this may lead to valve damage or piston issues. Correct synchronization protects engine components and extends engine life.
-
-

#551 Common question asks
How do you perform multi-carb synchronization and tuning?
-

On multi-carb 4-stroke engines we connect a vacuum gauge to each carburetor or intake runner and balance the throttle plates at idle and off-idle. On 2-stroke outboards we synchronize the throttle plates and linkage to the service manual. Then we set the idle mixture and linkage and check the engine under load across the rpm range.
-
-

#549 Common question asks
What symptoms indicate that my carburetors need synchronization?
-

Common symptoms include rough or unstable idle, hesitation during acceleration, uneven engine sound, increased fuel consumption, and excessive vibration. If your engine feels unbalanced or doesn't respond smoothly, synchronization may be needed; we check the ignition, compression and vacuum leaks first.
-
-

#547 Common question asks
What is multi-carb synchronization and why is it important?
-

Multi-carb synchronization ensures that all carburetors deliver the same amount of air-fuel mixture to each cylinder. When carbs are out of sync, the engine runs rough, loses power, and consumes more fuel. Proper synchronization restores smooth idle, balanced power delivery, and optimal engine performance.
-
-

#29 Common question asks
Can a faulty carburetor damage my marine engine?
-

Yes. A malfunctioning carburetor can cause a lean or rich fuel mixture, leading to overheating, misfires or engine damage over time. Fixing it early helps prevent more expensive engine repairs.
-
-

#27 Common question asks
Do you provide a warranty on carburetor repairs?
-

Yes. Our workmanship is warranted for 90 days from the invoice date; parts carry their manufacturer's warranty.
-
-

#25 Common question asks
What brands of marine carburetors do you service?
-

We work on carburetors on MerCruiser/Quicksilver, OMC (Johnson/Evinrude) and older Yamaha two-stroke engines, as well as Holley Marine, Rochester (2GC and 4MV Quadrajet), Mercarb, Weber and Edelbrock marine carburetors.
-
-

#23 Common question asks
Do you offer mobile carburetor repair service at the dock?
-

Yes. We diagnose, adjust and repair carburetors at your boat in San Pedro, Long Beach and our other harbors from Marina del Rey to Newport Beach. Each visit has a one-way trip fee by distance, from $30 in San Pedro to $110 in Newport Beach.
-
-

#21 Common question asks
How long does a marine carburetor rebuild take?
-

The rebuild itself usually takes 2-4 hours of labor. When your boat is ready depends on getting the right kit for your carburetor, and we tell you the expected timing with your written estimate.
-
-

#17 Common question asks
Can a marine carburetor be rebuilt instead of replaced?
-

Yes. In many cases a rebuild brings a carburetor back to proper function without the cost of a replacement. A rebuild includes full disassembly and cleaning, new gaskets and needle and seat, float adjustment, jet inspection and adjustment to the maker's settings. If the body is corroded or the throttle shafts are badly worn, we tell you and quote a replacement instead.
-







