Home Repair

Fuel Injector Repair

Boat fuel injector repair in Long Beach and San Pedro: injector testing and cleaning, diesel injection pump timing, and MPI and EFI system diagnostics.

  • 3 services
  • Labor $150/hr
  • Trip fee from $30
  • At your slip or in the shop
View as Grid List

3 Items

Set Descending Direction
  1. Diesel Injection Pump Timing & Calibration
    Rating:
    100%
    $150 /hr
    Usually 2–4 hours
  2. MPI & EFI System Diagnostics
    Rating:
    100%
    $150 /hr
    About 1 hour to diagnose, then a quote
per page

Marine Fuel Injector Repair in Long Beach and San Pedro

We test, clean and repair fuel injection on gasoline and diesel boat engines, from MPI and EFI gas engines to diesel injectors and injection pumps. We work at your slip, dock or storage yard from Marina del Rey to Newport Beach, or at our San Pedro shop.

What the work covers

  • Injector cleaning and restoration: fuel injector repair covers testing the injectors, cleaning the ones that can be saved and replacing the ones that cannot. Parts are quoted with the job.
  • Gas MPI and EFI engines: MPI and EFI system diagnostics. We check fuel pressure, read fault codes and look at sensors and wiring to find the cause.
  • Diesel injection: diesel injection pump timing and calibration. Timing or fuel delivery that is off can cause hard starting, smoke and lost power. We set the pump timing on the engine; calibration or a rebuild of the pump is done by a diesel injection shop we work with or refer you to, and their charge is listed on your estimate.

Many injection problems start with the fuel. Gas that sits for months can leave varnish in injectors, and water or dirt in diesel fuel can wear injectors and pumps. Clean fuel and fresh filters protect the system.

Signs of an injector problem

  • Hard starting or a rough idle
  • Misfires or hesitation when you open the throttle
  • Black smoke or a new knock on a diesel
  • Fuel use that keeps climbing, or a fuel smell; if you smell raw fuel, leave the engine off and air out the boat
  • A warning light or fault code on an EFI engine

Questions about fuel injector repair

Can injectors be cleaned, or do they need replacing?

Often they can be cleaned and tested. An injector that is worn, cracked or leaking needs replacing. We test first and quote the work before any of it is done.

Is it the injectors or the fuel pump?

Both can cause hesitation and lost power. A fuel pressure test helps tell them apart. If pressure is low, the problem may be the pump or a clogged filter. See fuel pump repair.

Book a visit: submit a ticket with the boat, where it is kept and what the engine is doing, or call (562) 542-7296.

See also: heart of your boat engine rebuild.

Questions

Items 11 to 20 of 21 total

Page
Show per page
  1. #972 Common question asks Dec 17, 2025

    Do you repair issues found during MPI & EFI diagnostics?

    1. Fryderyk Florczak answers Dec 17, 2025

      Yes. After the diagnosis you get a written estimate, and once you OK it we repair or replace the faulty injectors, sensors or wiring.

  2. #970 Common question asks Dec 17, 2025

    Can diagnostics prevent engine breakdowns?

    1. Fryderyk Florczak answers Dec 17, 2025

      They can help. Finding a failing sensor or a fuel delivery problem early lets you fix it before it leaves you stranded or causes bigger damage.

  3. #968 Common question asks Dec 17, 2025

    How do you perform MPI & EFI diagnostics?

    1. Fryderyk Florczak answers Dec 17, 2025

      We use specialized diagnostic tools to read engine sensors, monitor fuel delivery, and analyze engine performance. This allows us to identify problems such as clogged injectors, faulty sensors, or wiring issues accurately.

  4. #966 Common question asks Dec 17, 2025

    What is MPI & EFI and why is diagnostic testing important?

    1. Fryderyk Florczak answers Dec 17, 2025

      MPI (Multi-Point Injection) and EFI (Electronic Fuel Injection) are systems that deliver fuel efficiently to your engine. Diagnostics help detect issues like misfires, poor fuel economy, or sensor malfunctions before they lead to serious engine problems.

  5. #246 Common question asks Jun 22, 2025

    How do I know if the fuel injectors or fuel pump are causing issues?

    1. Lukas answers Jun 22, 2025

      We test before replacing anything: stored codes on EFI engines, fuel pressure, and each injector's electrical signal. Low fuel pressure points to the pump, a filter or the regulator; good pressure with one weak cylinder points to that injector. You get a written estimate for the repair before we do it.

  6. #244 Common question asks Jun 22, 2025

    Can old fuel or ethanol damage marine injectors?

    1. Lukas answers Jun 22, 2025

      Yes. Ethanol-blended gasoline takes on water, and fuel that sits leaves varnish and deposits, which can clog or corrode injectors. Fresh fuel, a stabilizer when the boat will sit, and fuel filters and water separators changed on your engine maker's schedule do the most to prevent it.

  7. #242 Common question asks Jun 22, 2025

    Do you repair fuel injectors for Yamaha and Mercury engines?

    1. Lukas answers Jun 22, 2025

      Yes. We work on fuel-injected Yamaha and Mercury outboards and MerCruiser sterndrives, and on other marine makes such as Suzuki and Honda. Replacement parts are the marine parts specified for your engine, and we quote them before fitting them.

  8. #240 Common question asks Jun 22, 2025

    How much does it cost to service boat fuel injectors?

    1. Lukas answers Jun 22, 2025

      Labor is $150 an hour, plus a trip fee for work at your boat ($30 in San Pedro up to $110 in Newport Beach). Removing, cleaning, testing and refitting a set of injectors usually takes 2-4 hours, depending on the engine and how easy the injectors are to reach. Parts are extra, and you get a written estimate before any work starts.

  9. #238 Common question asks Jun 22, 2025

    How do you clean and test marine fuel injectors?

    1. Lukas answers Jun 22, 2025

      We take the injectors out, clean them and test them, so a weak or leaking injector shows up before it goes back in. Worn O-rings and filter baskets are replaced. An injector that still fails the test is quoted for replacement, and nothing is replaced without your OK.

  10. #236 Common question asks Jun 22, 2025

    Can dirty fuel injectors cause engine knocking or vibration?

    1. Lukas answers Jun 22, 2025

      They can. A clogged or leaking injector upsets the fuel delivery to its cylinder, which can cause misfiring, rough running and vibration, and a lean cylinder on a gasoline engine can also knock. Knocking has other causes too, such as the wrong fuel or ignition timing, so we diagnose before replacing anything.

Items 11 to 20 of 21 total

Page
Show per page