Home Repair

Propeller and Shaft Repair

Propeller and prop shaft repair in Long Beach and San Pedro: dings, spun hubs, re-hubbing, shaft alignment and cutless bearings. Get a quote.

  • 3 services
  • Labor $150/hr
  • Trip fee from $30
  • At your slip or in the shop
View as Grid List

3 Items

Set Descending Direction
  1. Prop Shaft Alignment & Cutless Bearing Replacement
    Rating:
    100%
    $150 /hr
    Usually 4–8 hours
  2. Propeller Pulling & Re-Hubbing Service
    Rating:
    100%
    $150 /hr
    Usually 1–2 hours
per page

Propeller and Shaft Repair in Long Beach and San Pedro

We handle propeller and prop shaft work for outboard, sterndrive and inboard boats; blade repair is done by a prop shop. We work at your slip, dock or storage yard from Marina del Rey to Newport Beach, or at our San Pedro shop.

What the work covers

  • Propeller repair: propeller repair brings back blade shape, pitch and balance after a strike, so the prop pushes the boat the way it should. We remove the prop, a prop shop we work with or refer you to repairs it, and we refit it.
  • Stuck props and hubs: propeller pulling and re-hubbing. A seized inboard prop comes off the shaft with a proper puller; that is done with the boat out of the water, or by a diver we refer you to. Outboard and sterndrive props get a new hub when the old one slips.
  • Shafts and bearings: prop shaft alignment and cutless bearing replacement. A worn cutless bearing in the strut or a shaft out of line causes vibration and wears the shaft seal and transmission parts. Cutless bearing work needs the boat out of the water, or a diver we refer you to.

Parts are quoted with the job, and so are any haul-out, diver or prop shop charges; anything we find during the check is quoted before any work is done.

Signs your prop or shaft needs attention

  • New vibration at cruising speed
  • RPM climbs and the boat does not speed up
  • Dings, bends or missing chunks on the blades
  • Lost top speed or higher fuel use
  • A clunk or rumble from the shaft area

Questions about propeller repair

Why does my engine rev up while the boat barely speeds up?

On outboards and sterndrives, a spun hub is a common cause, often after the prop hits something. The hub inside the prop slips, so the engine revs while the prop does not keep up. Re-hubbing fixes it. If the hub is fine, the problem may be in the drive. See outdrive repair.

Is a small ding worth fixing?

Often, yes. Even a small bend changes how the blade loads and can cause vibration. Over time that vibration wears bearings and seals in the drive or transmission, so fixing it early protects those parts.

Book a visit: submit a ticket with the boat, where it is kept and what you feel at the helm, or call (562) 542-7296.

See also: spun prop hub signs causes and when to re hub a propeller.

Questions

Items 21 to 21 of 21 total

Page
Show per page
  1. #304 Common question asks Jun 22, 2025

    What are signs that my boat propeller needs repair?

    1. Lukas answers Jun 22, 2025

      Vibration, lower top speed, higher fuel use or uneven engine RPM often point to a damaged or unbalanced prop. We inspect it, and if it needs repair, a propeller shop we work with reshapes and balances it before we refit it.

Items 21 to 21 of 21 total

Page
Show per page